UAP-AC 使用 POE供电 (会有问题,需用POE+)

网件的 PROSAFE®8个千兆端口+2个千兆SFP光纤端口PoE****智能交换机
GS110TP

[td=1,6,64] 网络协议和标准 [td=214]

IEEE 802.3i 10BASE-T

[td=214]

IEEE 802.3u 100BASE-TX

[td=214]

IEEE 802.3ab 1000BASE-T

[td=214]

IEEE802.3z 1000BASE-X

[td=214]

IEEE 802.3x 全双工流量控制

[td=214]

IEEE802.3af 以太网供电

他可以为 UAP-AC 进行 POE供电吗? 感觉很少有交换机 支持 IEEE802.3at 的。

UAP-AC 在被 POE 供电可能一些问题,因此 POE+ 是必须的(结论源自 以下)。
----------更新-----------
我这几天在 ubnt 的英文 论坛里查询了一番,发现了一个很有用的 帖子,由于论坛需要审核链接,我就把有用的回帖部分 发出来,以供大家查阅。

Mike,

After testing this for a few weeks I think we can safely say the problem was not with the software. I ran the 3.x software for less than tow days and experienced network drops again. As agreed I inserted the Ubiquty power injector to power the access point.

It has been two to three weeks now and have not had the access point drop anything again. From this I am to deduce that the power source being the problem. I have not seen any logs in the PoE swtich that showed any power drop or issues. Guess I will have to replace that.

Thank you Mike!

Erik

如上~

价格不菲吧

呵呵。。。。。

楼主用过了?价格如何?

没用过,我想问问这个。
不好意思 我打字的时候少写了几个字,歧义了~